RENEW_RESERVATION_RESEND_INTERVAL (Parameter)

Parameter: RENEW_RESERVATION_RESEND_INTERVAL

Definition

The minimum time interval (in seconds) between two attempts to send a renew reservation notification

Description and Use

This system parameter specifies the minimum time interval (in seconds) between two attempts to send a renew reservation notification. When this time has passed, the SAP CC system sends the notification again to the registered client application or system.

Note

This time interval must be greater than the average time needed by the listener defined in the charging client to process and acknowledge a reservation renewal notification.

Syntax and Constraints

Defined Constraints

The SAP CC Core Server system verifies the following constraints:

Instance Type	Constraint
Rater instances	The parameter must be greater than or equal to 0 .

Additional Information

Refer to the RENEW_RESERVATION_RESEND_ATTEMPTS system parameter for more information and user assistance.

Technical Details

For more information, consult this section.

Name

RENEW_RESERVATION_RESEND_INTERVAL

The minimum time interval (in seconds) between two attempts to send a renew reservation notification

Category Parameter

Type Integer

Access (RO/RW)

RW(+): Dynamic Read / Static and Dynamic Write

An immediate change is possible but is temporary. When it is relevant, change the permanent settings used by the SAP CC Core Server system when it restarts.

Use the Admin+ user interface to change the runtime values or the permanent values of this system parameter in an instance of the SAP CC Core Server system or in multiple instances.

Groups

Instance Type

This system parameter is only available in the following type of instances in a running SAP CC Core Server system:

rater

Default Value (Factory Settings)

The predefined default value is:

Instance Type	Value
Rater	`1`

You can use a default value to reset the runtime value or the restart value (persistent) in the Admin+ user interface.

Note

A default value is part of the factory settings of the SAP CC Core Server systems. It differs from the original value set during the installation or after the Customizing activities.

In Admin+, you can reset a parameter value to this default value, but it is not recommended:

This value may differ from the original value set during the installation of your SAP CC system.
Note that it may also differ from the value defined by the implementation project team and set during the Implementation Phase of the integration project.

Verify the values in your running SAP CC systems before to use the reset command.

Constraints

The SAP CC system checks the following constraints:

Rater instances

The parameter must be greater than or equal to 0 .