CLEANUP_THREAD_COUNT (Parameter)

Parameter: CLEANUP_THREAD_COUNT

Definition

The number of threads reserved for performing the cleanup process into each rater instance

Description and Use

This system parameter defines the number of threads per rater instance dedicated to the cleanup process in the SAP CC system.

System Configuration (Advanced): Tuning

Fine-Tuning the Parameter Value

You can fine-tune the parameter values. For each type of instances in your SAP CC system, see the SAP CC Sizing and Performance Tuning Guide.

Syntax and Constraints

Defined Constraints

The SAP CC Core Server system verifies the following constraints:

Instance Type	Constraint
Rater instances	The parameter must be greater than or equal to 1 . The constraint(s) of the parameter SQLHELPER_CONNECTION_COUNT must be verified (as part of these constraint(s)).

Technical Details

For more information, consult this section.

Name

CLEANUP_THREAD_COUNT

The number of threads reserved for performing the cleanup process into each rater instance

Category Parameter

Type Integer

Access (RO/RW)

RW(+): Dynamic Read / Static and Dynamic Write

An immediate change is possible but is temporary. When it is relevant, change the permanent settings used by the SAP CC Core Server system when it restarts.

Use the Admin+ user interface to change the runtime values or the permanent values of this system parameter in an instance of the SAP CC Core Server system or in multiple instances.

Groups

Instance Type

This system parameter is only available in the following type of instances in a running SAP CC Core Server system:

rater

Default Value (Factory Settings)

The predefined default value is:

Instance Type	Value
Rater	`1`

You can use a default value to reset the runtime value or the restart value (persistent) in the Admin+ user interface.

Note

A default value is part of the factory settings of the SAP CC Core Server systems. It differs from the original value set during the installation or after the Customizing activities.

In Admin+, you can reset a parameter value to this default value, but it is not recommended:

This value may differ from the original value set during the installation of your SAP CC system.
Note that it may also differ from the value defined by the implementation project team and set during the Implementation Phase of the integration project.

Verify the values in your running SAP CC systems before to use the reset command.

Constraints

The SAP CC system checks the following constraints:

Rater instances

The parameter must be greater than or equal to 1 .
The constraint(s) of the parameter SQLHELPER_CONNECTION_COUNT must be verified (as part of these constraint(s)).