PCA Dashboard 
You use this activity to record the results of your testing, analysis, repair, and inspection of PCA boards in the system. This activity allows you to view and interact with graphical schematics and CAD files of the boards you are working on.
Prerequisites
You have set up the following rules in System Rule Maintenance Maintenance (see Serialization Rules and PCA Dashboard Rules):
D2B Server
Copy NC Data
Rules
The following table describes rule and settings that you can change for this activity in Activity Maintenance:
Rule |
Setting |
|---|---|
ALLOW_PARTIAL |
YES: The partial processing of SFC numbers in the POD for immediate scrap is allowed NO (default): The partial processing of SFC numbers in the POD for immediate scrap is not allowed. The entire SFC number quantity is dispositioned. |
Fields
The following table describes fields requiring explanation:
Field |
Description |
|---|---|
Disposition Quantity |
Displays the value of the quantity entered in the POD in the Quantity field Note that this field appears if the ALLOW_PARTIAL activity rule is set to yes. |
Total Defect Count Quantity |
Displays the sum value of all defect count values entered for the NC codes that were logged for the SFC number Note that this field appears if the ALLOW_PARTIAL activity rule is set to yes. |
SFC Act |
Displays more detail about the SFC number. The POD displays the SFC report in a separate screen. |
Signoff |
Indicates that you have started, but have not finished the SFC numbers listed in the Active Work list. The POD moves the SFC numbers from the Active Work list to the Task list, with the status of In Queue. |
D2B |
Displays and hides the graphical CAD files for the SFC numbers in the PCA dashboard |
IPASS |
Immediate pass You can use it when you log a test failure in error or pull samples. Completes the SFC number and sends it to the next operation as though it passed the test. Does not log a repair or verify defects. Note that it is enabled only in Analysis or Combined mode. |
FPASS |
Forced pass You can use it when you retest an SFC number and verify the defect. Completes the SFC number and sends it to the next operation instead of moving it back to the test operation. Note that it is enabled only in Repair or Combined mode. |
Send Event |
Enables sending of a notification |