TRANSACTION_DETAIL_PRECISION (Parameter)

System Parameter Reference

Parameter: TRANSACTION_DETAIL_PRECISION

Definition

The precision of the numerical transaction details

Description and Use

This system parameter defines the number of decimal places for rounding numerical transaction details.

Syntax and Constraints

The possible values range from 0 to 6.

Recommendation

SAP recommends that you set up the same value to the TRANSACTION_DETAIL_PRECISION parameter for each instance of the SAP CC Core Server system to avoid inconsistency in computed values.

Defined Constraints

The SAP CC Core Server system verifies the following constraints:

Instance Type	Constraint
Rater instances	The parameter must be less than or equal to 6 . The parameter must be greater than or equal to 0 .

Technical Details

For more information, consult this section.

Name

TRANSACTION_DETAIL_PRECISION

The precision of the numerical transaction details

Category Parameter

Type Integer

Access (RO/RW)

RW(-): Dynamic Read / Static Write

An immediate change is not possible. For a deferred and permanent change, use the set command of the Admin+ user interface to change the parameter value for a specific type of instance in the SAP CC Core Server system. A restart is needed for permanent changes.

Groups

Instance Type

This system parameter is only available in the following type of instances in a running SAP CC Core Server system:

rater

Default Value (Factory Settings)

The predefined default value is:

Instance Type	Value
Rater	`6`

You can use a default value to reset the runtime value or the restart value (persistent) in the Admin+ user interface.

Note

A default value is part of the factory settings of the SAP CC Core Server systems. It differs from the original value set during the installation or after the Customizing activities.

In Admin+, you can reset a parameter value to this default value, but it is not recommended:

This value may differ from the original value set during the installation of your SAP CC system.
Note that it may also differ from the value defined by the implementation project team and set during the Implementation Phase of the integration project.

Verify the values in your running SAP CC systems before to use the reset command.

Constraints

The SAP CC system checks the following constraints:

Rater instances

The parameter must be less than or equal to 6 .
The parameter must be greater than or equal to 0 .