Parameter: TAX_ROUNDING_MODE
Definition
Description and Use
This system parameter specifies the method for rounding the tax amounts. It is used if the precision defined by the TAX_PRECISION parameter was modified.
Syntax and Constraints
The possible values are:
-
NEAREST: Rounds towards the nearest neighbor. If the discarded fraction is >= .5, then raise, otherwise truncate. -
TRUNCATE: Truncates the amount. The fraction is discarded. -
RAISE: Increments the digit prior to a non zero discarded fraction.
Caution
Set up the same value to this parameter for each instance to avoid inconsistency in computed amounts.
See Also
TAX_PRECISION - The precision of tax amounts computed by the SAP CC system
Additional Information
See the TAX_PRECISION parameter for more information and user assistance.
Technical Details
For more information, consult this section.
| Name | TAX_ROUNDING_MODE
|
|||||||
| Category | Parameter | |||||||
| Type | String | |||||||
| Access (RO/RW) |
RW(+): Dynamic Read / Static and Dynamic Write An immediate change is possible but is temporary. When it is relevant, change the permanent settings used by the SAP CC Core Server system when it restarts. Use the Admin+ user interface to change the runtime values or the permanent values of this system parameter in an instance of the SAP CC Core Server system or in multiple instances. |
|||||||
| Groups | ||||||||
| Instance Types |
This system parameter is available in the following types of instances in a running SAP CC Core Server system:
|
|||||||
| Default Values (Factory Settings) |
The predefined default values are:
You can use a default value to reset the runtime value or the restart value (persistent) in the Admin+ user interface. Note A default value is part of the factory settings of the SAP CC Core Server systems. It differs from the original value set during the installation or after the Customizing activities. In Admin+, you can reset a parameter value to this default value, but it is not recommended:
reset command.
|
|||||||