RATING_SESSION_SQLHELPER_DB_TIMEOUT (Parameter)

Parameter: RATING_SESSION_SQLHELPER_DB_TIMEOUT

Definition

The frequency (in seconds) of ping operations sent to the Session Database

Description and Use

This system parameter defines the frequency (in seconds) of "ping" operations that are sent to the Session Database. After 2 failed ping operations, the instance is considered as down. When database connections are down, ping operations are used to reconnect automatically to the Session database.

To enable ping operations on the Session Database, set a value that is greater than 30 seconds.

To disable ping operations on the Session Database, set the value to 0.

Technical Details

For more information, consult this section.

Name

RATING_SESSION_SQLHELPER_DB_TIMEOUT

The frequency (in seconds) of ping operations sent to the Session Database

Category Parameter

Type Integer

Access (RO/RW)

RW(-): Dynamic Read / Static Write

An immediate change is not possible. For a deferred and permanent change, use the set command of the Admin+ user interface to change the parameter value for a specific type of instance in the SAP CC Core Server system. A restart is needed for permanent changes.

Groups

Backends: Database Management Settings

Instance Type

This system parameter is only available in the following type of instances in a running SAP CC Core Server system:

rater

Default Value (Factory Settings)

The predefined default value is:

Instance Type	Value
Rater	`0`

You can use a default value to reset the runtime value or the restart value (persistent) in the Admin+ user interface.

Note

A default value is part of the factory settings of the SAP CC Core Server systems. It differs from the original value set during the installation or after the Customizing activities.

In Admin+, you can reset a parameter value to this default value, but it is not recommended:

This value may differ from the original value set during the installation of your SAP CC system.
Note that it may also differ from the value defined by the implementation project team and set during the Implementation Phase of the integration project.

Verify the values in your running SAP CC systems before to use the reset command.