Use
You use this procedure to monitor, set and change memory-related parameters for each ITS instance.
You can display and edit values for the parameters listed in the following table:
Category |
Parameter Name |
Parameter Description |
General parameters |
MaxWorkThreads |
Minimum workthreads. |
MinWorkThreads |
Maximum workthreads. |
|
MaxSessions |
Maximum sessions. |
|
Workthread container sizes |
MinReqSize |
Minimum request size. |
MaxReqSize |
Maximum request size. |
|
MinRespSize |
Minimum response size. |
|
MaxRespSize |
Maximum response size. |
|
MinCtxtSize |
Minimum context size. |
|
MaxCtxtSize |
Maximum context size. |
|
Session container sizes |
MinHrnpSize |
Minimum HRNP size. |
MaxHrnpSize |
Maximum HRNP size. |
|
MinRfcSize |
Minimum RFC size. |
|
MaxRfcSize |
Maximum RFC size. |
|
MaxSessionContextSize |
Maximum session context size. |
For further information about these parameters, see
Setting Performance Parameters.Procedure
You see a screen similar to the following:
Parameter |
Description |
|
PerfMemTune |
0 |
Memory tuning disabled (default). |
1 |
Memory tuning enabled. |
You see a screen similar to the following:
The values displayed here include:
ITS Administration uses these values to calculate and display the overall statistics and the total memory requirement displayed in the Results column.
To recalculate and display the overall statistics before saving, choose Calculate.
The Total Memory value is accompanied by a traffic light, which acts as a warning mechanism. This value is a worst case calculation. Normally, the ITS would use a lot less memory. Depending on this value, the traffic light is: