Specifying Inbound Interfaces and Mappings

With the following steps you can specify mappings for the defined receiver inbound interfaces and specified cases.

You have created an integrated configuration and have specified at least one receiver.

1. Choose the Receiver Interfaces tab.

2. Highlight the receiver (party/communication component) for which you want to specify an inbound interface (under Receiver ).

3. Under Receiver Interfaces and Mappings specify a receiver interface for each outbound interface operation ( Name and Namespace fields).

   Only interfaces that are defined for the receiver are offered in the input help.

4. You can also specify an operation mapping for each inbound interface.

5. When using parameterized mapping programs:

   Configure the parameters of the parameterized mapping program.

   If you reference an operation mapping with a parameterized mapping program in an integrated configuration, the parameters of the mapping program are displayed in the integrated configuration (under Parameters ). You can transfer values to the mapping program using the input fields in the Value column. The input help is determined by which category the parameter is from. If the parameters are from the Simple Type category, the expression editor for constants is called. If the parameters are from the Adapter category, the input help for communication channels is called.

   If you have saved constants for certain parameters of the message mapping signature in an operation mapping, these parameters are not displayed in the integrated configuration that references the operation mapping. This is because in this case the value of the parameter results from the constants.

You can also specify a multi-mapping and configure a message split.