Creating a Configuration Scenario 
A configuration scenario consists of multiple service definitions. A configuration profile can be assigned to one or more service definitions in a configuration scenario.
You can create multiple configuration scenarios for your system infrastructure.
The same service definition can be active within multiple configuration scenarios. If a service definition is not active in any configuration scenario, the corresponding endpoint is deleted.
When to use a Configuration Scenario
You should use a configuration scenario in the following situations:
At least one system is connected to more than one system, and service groups are used for receiver determination in the system's outbound interfaces
Many interfaces need to be configured in each system
At least one system configuration needs to be transferred from a development or test system to a production landscape
Note
If you have SAP NetWeaver 7.02 SP08 or later and you use service groups, you can use central business scenario configuration. For more information, see Configuring a Central Business Scenario.
Procedure
Note
These steps are for SOA Manager running in a non-central system.
To create a configuration scenario, perform the following steps:
Go to the Service Administration tab.
Choose Business Scenario Configuration.
An overview of configuration scenarios is displayed.
Choose Create.
Specify a name and a description for the configuration scenario.
Choose Create.
Under Connections, choose Create.
Specify a Consumer System, Service Group and/or a Provider System.
Choose Search.
A list of matching service groups is displayed.
Select a service group and choose Create.
The newly created connection is shown in the Connections table.
You can Check and Ping the connection.
Choose Save.
Note
You do not need to add a provider configuration.