The Configure <Connector> task panel enables you to define attributes for a connector. A connector is a point in the data flow representing a connection that channels data from/to points outside the open component.
The following table describes the properties and attributes of this model element:
Group |
Property |
Description |
---|---|---|
General |
Name |
The name of the connector, to be displayed on the Design board and used when creating references to the connector. |
Client event |
The namespace of the client event that you want to activate. This property is available only for connectors of type Signal In and Signal Out. |
|
Scope |
Defines how the data share can be accessed, as follows:
This property is available only for connectors of type Data Share. |
|
Target Component Note The properties in this group are available only for connectors of type Navigate. End of the note. |
Target Name |
The name of the nested component in the model. |
Type |
The type of the target component. |
|
Location |
The location in which the target component is stored. |