You use the ResponseOnewayBean module to convert an inbound message to an asynchronous message. You use the module in an async/sync bridge for sender and receiver channels.
If the thread that enters the module is part of a suspended transaction, the transaction is resumed.
If you are using the module in a sender adapter, it calls a receiver.
If you are using the module in a receiver adapter, it calls the messaging system.
The inbound data in the module is application response messages.
You have configured a communication channel and are on the Module tab page in change mode.
Add the Module in the Processing Sequence
The Module Key is displayed.
Your entries depend on whether you are using the module in a sender or receiver adapter.
Add Parameters in the Module Configuration for the Sender Adapter
If you do not set this parameter, the information is taken from the message header of the message.
If you do not set this parameter, the information is taken from the message header of the message.
If you do not set this parameter, the system searches for the collaboration agreement corresponding to the information from the message header of the message.
Under Parameter Value, enter the adapter type.
Under Parameter Value, enter the adapter namespace.
Under Parameter Value, enter the name of the receiver channel.
The interface name of the message is replaced with your entry for interfaceOnFault and interfaceNamespaceOnFault, or the name of the application error in the application error message if you enter true under Parameter Value.
If you enter false, the original interface name is used.
Under Parameter Value, enter the name of the interface.
Under Parameter Value, enter the namespace of the interface.
Add Parameters in the Module Configuration for the Receiver Adapter
The interface name of the message is replaced with your entry for interfaceOnFault and interfaceNamespaceOnFault, or the name of the application error in the application error message if you enter true under Parameter Value.
If you enter false, the original interface name is used.
Under Parameter Value, enter the name of the interface.