Often, the same values are assigned to the same fields in different inspection plans. In such cases, it is advisable to predefine these fields in a profile and call them up when maintaining an inspection plan, thereby reducing the amount of work involved in entering data.
The information contained in the profile is a default that you can change, when you create and change inspection plans.
Note
In addition, you can define profiles in Customizing for QM.
In the plan overview, header detail screen, operation overview or inspection characteristic overview of the inspection plan, choose
.The Default Values for General Data screen appears.
Enter the following data, as required:
Field |
What You Should Know |
|
Default value for the base unit of measure of the material to be produced |
|
Default value for the plant that applies to all operations |
|
Default value for the area, in which the inspection plan is to be used |
|
Default value for the inspection plan status |
|
Default value for the increment that is to be used for automatic numbering of the operations |
|
Default value for the base unit of measure of the material to be produced |
|
Default value of the denominator for the conversion into base units of measure |
|
Default value of the numerator for the conversion into base units of measure |
To call QM-specific default values, choose
QM data
.
The Default Values for Quality Assurance screen appears.
Enter the following data, as required:
Field |
What You Should Know |
|
Default value for the intervals, in which the inspection characteristic numbers are to be created in the inspection plan. |
|
Increments that are to be used if new inspection characteristics are added between already existing characteristics. |
|
Default value for the intervals, in which the assignment numbers are to be created |
|
Base unit of measure for sample determination for a characteristic |
|
Factor for calculating the inspection quantity The system uses this factor to calculate the size of the single sample that is required for the inspection of the characteristic |
Choose
Continue
.
The screen from which you called the profile appears again.