Parameter Views at Tool Level (SAP Library - Incentive and Commission Management)

Parameter Views at Tool Level

To use a parameter view at tool level, you need to note the following:

Create the CACS_S_LOS_ST_ODT_K key in the table include instead of CACS_S_LOS_ST_OD_K.

Call up the CACS_LOS_GET_PARAM_ODT function module instead of CACS_LOS_GET_PARAM_OD.

You specify the parameter view at tool level instead of function level in Customizing for the Commission System under Commissions -> Tools -> Logical Service: Maintain Tools.

You can also use parameter views at tool level and at function level at the same time. You need to create the tables for the parameter views at tool level and function level, then call up both function modules to get the parameters.

The table below summarizes the differences between using parameter views at function and at tool level:

Parameter View	Key Field in Table	Function Module
Defined at tool level, based on the object.	CACS_S_LOS_ST_ODT_K	CACS_LOS_GET_PARAM_ODT
Defined at function level, based on the object.	CACS_S_LOS_ST_OD_K	CACS_LOS_GET_PARAM_OD