Entering content frameFunction documentation Editing QM Data in the Header Locate the document in its SAP Library structure


If quality inspection accompany production, the routing can take over the role of an inspection plan.
You determine the basic data for the inspection in the QM data of the header (that is, in the data for quality management).


You have installed the application component Quality management (QM).
The following data exist there:


Use of Inspection Points

You plan inspections that accompany production in the operation that is affected. If an inspection is to be repeated at a certain interval during the operation, you can use inspection points to add more detail.

Inspection points for inspections during production are freely defined reference objects for entering inspection results below operation level. You group results from a certain interval in an operation together. The interval can be defined as refering to time (for instance 2 hours), a quantity (for instance 5 containers) or any chosen event.

In the QM data in the header you decide:

See also:

R/3 Library QM Quality Management, Quality Management in Logistical Processes ® QM in Production

Dynamic Modification of the Inspection Scope

You can dynamically modify the inspection scope to the expected quality level:

You use a dynamic modification rule to lay down the conditions under which inspections are tightened or reduced. On the basis of the rule the system evaluates the results of the last inspections. From the so determined inspection severity it lays down the inspection scope for the individual characteristics using a sampling procedure or further dynamic modification criteria.

In the QM data in the header you decide:

You always assign the sampling procedure to the characteristic

See also:

R/3 Library QM Quality Management, Dynamic Modification

External Numbering in Results Recording

For results recording you determine in the the header,



Leaving content frame