Identification

Use

To identify inspection points, you can define a combination of fields in Customizing. In such a field combination, user-defined fields as well as fields fixed by the inspection point type are defined with individual key words and an individual sequence.

There are inspection point types for equipment, functional locations, physical samples, and production. These inspection point types can be assigned individually in the user specifications if required. The following parameter IDs correspond to the following inspection point types:
Parameter ID Inspection point type
QB1 Equipment
QB2 Functional location
QB3 Physical sample
QBK Production

Examples

Wire basket/shift
A wire basket number uniquely identifies for all operations a production quantity for which inspection results should be recorded. For results recording, the shift should also be entered as additional information.
At the operation level, an inspection interval is predefined for every 50 units.
You can show this by the following inspection point identifier:

Predefined field dependent on inspection point type (' ')

	Field active	Key word

User fields	Field active	Key word
Text Length 18
Text Length 10
No. Length 10	1	Wire basket
No. Length 3	X	Shift
Date
Time

By marking the "Field active" column, you can make a field an optional field.
In order that an inspection point can be uniquely identified, the system only considers fields with an entry between 1 and 6 in the "Field active" column.

Vessel/Date/Time
In the process industry, liquids are produced in vessels. This operation can take several days. A sample is taken on an hourly basis (a time-based inspection interval, interval = 1 hour).
This can be be shown by the following inspection point identifier:

Predefined field dependent on inspection type (' ')

	Field active	Key word

User fields	Field active	Key word
Text Length 18
Text Length 10
No. Length 10
No. Length 3	1	Vessel
Date	2	Date
Time	3	Time

Test equipment
Test equipment is monitored in calibration inspections. Choose inspection point type 1 (inspection point for equipment). The equipment number 1 must be entered as an identifier. Since the equipment is test equipment, use 'test equipment' as the key word.

This can be be shown by the following inspection point identifier:

Predefined field dependent on inspection type ('1')

	Field active	Key word
Equipment	1	Test equipment

User fields	Field active	Key word
Text Length 18
Text Length 10
No. Length 10
No. Length 3
Date
Time

Note

Even if the test equipment type allows for certain fields, you can define additional user fields.

If you enter a value for the field combination in the task list header, this value is copied to the inspection lots.