IDoc Segments, Fields and Domain Values
The following section describes the individual segments of IDocs TPSLOC01, TPSDLS01, TPSSHT01 and SYSTAT01. The fields contained in the segments are all listed with name, data category with length, corresponding R/3 domains, mandatory field indicators and their meanings. In the connection to the field list, segment fields that have special properties, fixed values areas or non-R/3 functions are described in greater detail.
Adjustment and Setting of Domain Values
During communication between the R/3 system and the transportation planning system, adjustment and setting of many fixed values is necessary in order to guarantee correct and efficient planning and processing. The following adjustment procedures are therefore used to determine how and in which system adjustments need to be made.
Adjust. procedure |
Significance |
1 |
SAP sets the standard that must be implemented in the planning system |
2 |
Manual master data adjustment between the systems, R/3 is master system |
3 |
Different value areas are used in both the R/3 system and in the planning system. Duplicated or common values can be adjusted |
4 |
SAP copies the value area of the planning system for its development partner into the R/3 system |
5 |
The R/3 system is adjusted in Customizing to the planning system value area |
6 |
Translation / adjustment of technical expressions between the two systems |
7 |
Value area is fixed and was determined by agreement between SAP and development partners |
8 |
SAP defines a basic value which must be included in the planning system. It can be enhanced and must then also be enhanced in R/3 Customizing, if necessary |
9 |
The value area is specified using international standards (e.g. ANSI, ISO,...) |
A |
Electronic master data adjustment per data transfer, R/3 is the master system |
B |
Master data value that can be set as customer-specific and can only be adjusted in special circumstances |
The various adjustment procedures are listed in the table with the segment descriptions in the Adjustment column. If no specification is made here, then you only need to take the specifications on data formats into account.