If you set this indicator, the system treats the inspection lot size as the sample size.
When inspecting with a task list or
material specification, you must consider the following:
The sampling procedures defined in the inspection plan or material
specification are not taken into account in the sample determination for
inspection characteristics. (Instead, the system uses the sample determination rules that are predefined in
Customizing.)
The sample size of the inspection characteristics depends on whether the base unit of measure is a whole number:
If you define a 100% inspection for the material, you must manually valuate the inspection characteristics.
Note
In a 100% inspection, you inspect the characteristic to be inspected for all units of an inspection lot. This is not the same as a complete inspection of all inspection characteristics. If skips are allowed, the characteristics that are in a skip stage, retain their skip status. In this case, the suggested sample size is equal to the inspection lot size for such characteristics.