Recording Results by Lot 

  1. Call up the transaction as follows:
    2.

    Menu Path

    Logistics ® Quality Management ® Quality Inspection ® Worklist ® Results Recording

    Transaction Code

    QE51N

  2. Enter the following data:
    3.

    Field

    Data

    Plant

    1100

    Insp. lot origin

    04

    Material

    CH_4100

  3. Choose .
  4. Choose .
  5. Choose .
  6. Enter the following data:
    7.

    Field

    Data

    Measured value

    Valid measured value that lies within the upper and lower tolerances

  7. Choose . The status of the line is set to 5 (Processing is completed), and the characteristic is valuated with since the measurement value was within the tolerances.
  8. Choose .

    9. You can now enter the results for the characteristic 9502, Density.

  9. Enter the following data:
    10.

    Field

    Data

    Results / mean value

    Valid measured value that lies within the upper and lower tolerances

  10. Choose .
  11. Choose .

    12. You can now enter the results for the characteristic 9503, Solids content.

  12. Enter the following data:

    13.

    Field

    Data

    Measurement reading / offset

    Valid measured value that lies within the upper and lower tolerances

  13. Choose and repeat this entry three times to process the required number of samples. The system calculates and displays the mean value.

  14. Choose .
  15. Choose . You can now enter the results for the characteristic 9504, Gloss.
  16. Enter the following data:

    17. Field

    Data

    Results / mean value

    Valid measured value that lies within the upper and lower tolerances

  17. Choose .

  18. Choose . You can now enter the results for the characteristic 9505, Paint color.
  19. Enter the following data:
    20.

    Field

    Data

    Results / code

    Value help (F4)

    Select 80, Black, then choose .

  20. Choose .

  21. Choose .
  22. Write down the inspection lot number that is displayed to the left of material CH_4100 in the left screen section (above the Inspection by material specification line).
  23. Choose .
  24. Choose until the overview tree appears.

In the dialog box, choose Yes.