Show TOC

Assign Selection Variant to User

In this IMG activity, you can enter user parameters in your user master record. You can assign both your own or standard selection variants to a user parameter. As a result, the worklist that the system displays after you called the corresponding transaction is created:

If you do not assign a selection variant to a user parameter, the system first displays a selection screen after you have called the relevant transaction. This selection screen contains the selection criteria that have been predefined for the user parameter. You can change these criteria. The worklist only appears after you have chosen Execute.

There are user parameters along with standard selection variants and standard display variants for the following transactions:

Transaction User Parameter Standard Selection Variant Standard Display Variant
Worklist-maintain PI_VAR_WL_WRK SAP&PI_WL_WRK 0PI_WL_WRK
Worklist-check PI_VAR_WL_CHK SAP&PI_WL_CHK 0PI_WL_CHK
Worklist-complete PI_VAR_WL_CLS SAP&PI_WL_CLS 0PI_WL_CLS

Activities

To assign user parameters and selection variants to your user master record, proceed as follows:

1. Choose activity Assign Selection Variant to User.
The initial screen for user maintenance appears.
2. Enter your user and choose Change.
User maintenance appears.
3. Choose the Parameters tab page.
4. Enter the user parameters in the Parameters column and, if required, the selection variant in the Value column.
5. Save your entries.

Further Notes

If you use standard selection variants, you can also enter a plant and an operating group in your user master record. If you do so, the system does not prompt you for the plant and operating group after you have called the transaction but takes you directly to the worklist. The system automatically takes into account the plant and parameters assigned to your user master record.

Use the following parameters for the plant and operating group: