This parameter determines the maximum period of time in seconds that the system waits after a load check. The wait time is calculated based on the amount of available resources. The fewer resources that are available, the longer the wait time.
You can increase the wait time if you suspect that a resource bottleneck is about to occur, and if you cannot resolve the bottleneck and are prepared to accept a longer wait time.
The RFC resource check is active (see rdisp/rfc_use_quotas = 1).
Work area |
Dispatcher/task handler |
Unit |
Integer value (seconds) |
Standard value |
15 |
Dynamically changeable |
Local and on all servers |
Possible values are whole numbers between 1 and 120 (seconds).
Note the following documentation associated with this parameter: