tape_address_ctl_arch

This parameter is used by BRARCHIVE to define the control drivers for the mount or dismount commands. These commands cause the tapes to be mounted or dismounted when using a jukebox or autoloader, that is, backup_dev_type = tape_box|pipe_box).

If this parameter is not set, BRARCHIVE uses the drivers specified in the parameter tape_address_ctl.

Syntax Syntax

tape_address_ctl_arch = <dev>|(<dev_list>]

End of the code.

Default value: same as tape_address_rew_arch

Possible value:

<dev>: control driver address

Note Note

The number of tape_address_ctl_arch must agree with the number specified in tape_address_arch.

End of the note.