tape_address_arch

BRARCHIVE uses this parameter to identify device addresses for writing to a tape volume.

Syntax Syntax

```
tape_address_arch = <dev>|(<dev_list>)
```

End of the code.

Default value: same as tape_address

Possible values:

Addresses of backup devices (tape devices, no rewind) to be used by BRARCHIVE. If this parameter is not set, BRARCHIVE uses the devices defined in parameter tape_address.

Note Note

The number of device addresses in tape_address_arch must agree with the number of device addresses in tape_address_arch_rew.

End of the note.