Show TOC

Procedure documentationOverriding the Test Scope Manually

 

You can put solution documentation nodes in the test scope, even if they don't need to be tested, because of the optimization. You can also remove nodes from the test scope, which the optimization included in the test.

Procedure

  1. Choose the Solution Documentation tab page.

  2. Choose Expand All.

    All rows with nodes which are currently in the test scope, are selected.

  3. Go to the row for the node.

  4. To put a node in the test scope: Choose Ctrl, and select the rows which are not yet selected.

  5. To remove a node from the test scope: Choose Ctrl, and deselect the selected rows.

  6. Choose Apply and Save.

    The status in the Area of a Solution Documentation Node column allows you to identify whether a node was manually overridden. This column also contains status information for nodes that the system has moved to an area based, on the solution documentation options or criticality options.

    When you use the manual override function, you change the optimization sequence, so the test scope is recalculated for the specified test coverage and time required values.

    The graphical display is automatically updated. The manually added nodes are separated from the rest of the nodes, at the left-hand side of the diagram, by a black line. The manually removed nodes are separated from the rest of the nodes, at the right-hand side of the diagram, by a black line.

  7. Optional: To cancel all manual changes, choose Reset Manual Selection.