This procedure puts your custom functions in the Technical Monitoring and Alerting infrastructure. You implement Business Add-Ins (BAdIs) defined by SAP to adapt software to specific requirements. You must have implemented the BAdI BADI_ALERT_REACTION
.
The description of the BAdIs is beyond the scope of this document. See the SAP Community Network
under the following link:
http://wiki.scn.sap.com/wiki/display/TechOps/Alert+Consumer+BAdI+Interface
Caution
If you use this link, you accept that the contents of this page are not part of the SAP product documentation, and that you cannot derive expectations about the properties of the product from the information in this page.
You can make the settings for adding third-party components, on the following levels:
Level | Use |
---|---|
Global | You can set the default values for the entire System Monitoring. Make these settings in the |
Template (SAP or Customer) | You can overwrite the global settings on template level. These settings then apply to all managed objects for which this template is active. Make these settings in the template, in the step . |
Managed Object | You can overwrite the existing settings at global level or for specified templates or managed objects. Make these settings in the |
Alert Type | You can overwrite the existing settings at global level or for specified templates or alert types. Make this setting for the alert type, in the |
Note
Settings on a more specific level overwrite those on a more general level.
This procedure describes how you can make the settings for adding third-party components. The possible settings are almost the same on all levels.
Note
This procedure is in the Using Templates process. The settings which you make for a managed object in this procedure are only applied when you assign and activate its template, as described in Using Templates.
To adjust the settings, proceed as follows:
Go to the Solution Manager Configuration
(transaction SOLMAN_SETUP) step in the table above, for the level on which you want to make settings.
Go to change mode, and ensure that you are in the following tab, depending on the level:
Level | Tab |
---|---|
Global |
|
Template |
|
Managed Object | |
Alert Type |
|
Go to Expert Mode
(this is only necessary on global level).
In the drop-down list Third-Party Components
, choose Active
or Inactive
.
Note
You can also copy the general level settings on template and alert type levels. This is the default setting.
If you have activated the third-party component, go to the Third-Party Components
tab, to add the connector in the table Assigned Third-Party Components
.
If you want to activate the BAdIs for specific work modes, in the Work-Mode-Specific Template Settings
screen area, select the work mode, and make your changes.
Save your changes.