Show TOC

Procedure documentationPerforming a Self-Service

Prerequisites

You have created a self-service.

Procedure

  1. Select an engagement cycle.

  2. Go to the Services tab.

  3. Select the service you want to perform.

  4. Under Details, choose the Session Components tab.

  5. Choose the service session.

    A service session starts. Follow the self-service instructions.

    Note Note

    If you have identified necessary subsequent activities when performing a self-service, and have created issues for them, you can put these issues in your project management. For more information, see Assigning an Issue to a Service Session.

    End of the note.

  6. If a service session includes a questionnaire as well as the analysis session (e.g. the service session Security Optimization), choose Create Questionnaire.

    The questionnaire appears in a new line.

    If the session contains the relevant questions, Create Questionnaire is disabled.

  7. Close the service session.

Note Note

To reset the service session, and repeat all entries, choose Reset Session.

End of the note.

Note Note

Data is collected automatically before each session (transaction SDCCN). To display which data that was collected, select the link in the SDCCN Data Status column on the Sessions tab.

More information: Service Data Control Center.

End of the note.

Result

The status of the service session is displayed in the Session Components tab.