Show TOC

Procedure documentationDisplaying/Changing Development Configurations Locate this document in the navigation structure


To display an existing development configuration, proceed as follows:

  1. In the AS ABAP of your transport system, call transaction STMS.

  2. Choose System Overview.

  3. From your system landscape, double-click the system that you would like to edit the development configuration for.

  4. If a new development configuration exists for the system, then the symbol bar contains the Development Configuration pushbutton. Select this pushbutton to start the Configuration Service.

  5. The development configuration is loaded and can be configured.

    Note that you can only modify some values in the ABAP system in the Transport Management System (TMS). These are shown as write-protected in the Configuration Service.

    Note Note

    The name of the development configuration is the same as the system ID. It consists of three characters. The systems are managed using their system ID in TMS.

    End of the note.