Show TOC

Syntax documentationtape_address_rew_arch Locate this document in the navigation structure

BRARCHIVE uses this parameter to identify device addresses for writing to a tape volume.

Syntax Syntax

  1. tape_address_rew_arch = <dev>|(<dev_list>)
End of the code.

Default value: same as tape_address_rew

Possible value: addresses of backup devices (tape devices, rewind) to be used by BRARCHIVE. If this parameter is not set, BRARCHIVE uses the devices defined in parameter tape_address_rew.

Note Note

The number of device addresses in tape_address_rew_arch must agree with the number of device addresses in parameter tape_address_arch

End of the note.

See also tape_address_arch.