For this use case, all of the following apply:
As a result, the filter is displayed in the application and its value help is populated with all values retrieved by the configured value help request.
To configure the filter for this use case, you must enter basic data for the filter and information for the value help. No entries for the filter resolution are required.
You can configure whether multiple selections are possible in the value help or not. If multiple selections are possible you can specify one or several values that are used as default values or you can enter a function that determines the default values. If you select Automatic Values, all values are selected in the filter by default.
If only single selection is allowed, you can specify one value that is used as default value or you can enter a function that determines the default value. If you select Automatic Values, the first entry in the value help of the filter is automatically selected by default.
The option described above is depicted in the following figure: