Show TOC

Configuring Acknowledgements for a Sender IDoc Adapter (AAE)Locate this document in the navigation structure

Procedure

  1. Choose the sender communication channel on which you want to enable acknowledgement settings.

  2. Choose the Parameters tab and then, choose the Ack Settings tab.

  3. On the Acknowledgement Parameters area, enter the following settings:

    • System Ack Ok Requested

      Choose this option to receive XI system acks.

    • System Ack Error Requested

      Choose this option to receive XI system error acks.

    • Application Ack Ok Requested

      Choose this option to receive XI application acks.

    • Application Ack Error Requested

      Choose this option to receive XI application error acks.

    • ALEAUD Special Handling Needed

      Choose this option to enable the sender Java IDoc adapter to apply special handling to the incoming ALEAUD message. The adapter replaces the IDoc number of the ALEAUD message with the original IDoc number.

      Initially, the receiver Java IDoc adapter generates a unique IDoc number, which replaces the original IDoc number of the outbound message. This IDoc unique number is referred by the ALEAUD message. However, the ALEAUD message is not converted to an XI Ack message in this case.

Note

To configure acknowledgement settings when you use configuration from NWA, for the RFC parameter in the corresponding field of the communication channel, you have to enter the connection factory which you configured in NWA.

More information:

Configuring Communication Channel for a Sender IDoc Adapter (AAE

Configuring Resource Adapters and JCA Connection Factories in NWA

  • If you set the acknowledgement flags , you must enter the acknowledge connection details in the RFC Parameters tab.