Configuring the Receiver SAP Business Connector Adapter

You configure the receiver SAP Business Connector adapter to forward XML messages from the Integration Server or the PCK to the SAP Business Connector.

1. Select the Transport Protocol:
   • HTTP
   • HTTPS
2. Select the Message Protocol:
   • RFC XML with Envelope
   • IDoc XML (There is no party conversion)
3. Select the Adapter Engine on the Integration Server, or select a non-centrally installed Adapter Engine.

   This selection is not available in the PCK.

4. Under URL, enter the address of the SAP Business Connector.

   The start of the address must match the Transport Protocol you have selected.

   • If you have selected HTTP, the address must start with http://.
   • If you have selected HTTPS, the address must start with https://.

Define the Authentication Mode for Transport Protocol HTTPS

1. If you have selected HTTPS as the transport protocol, select the Authentication Mode:
   • User Name/Password

     Enter the user name and password for the user, and confirm.

   • Certificate Logon

     Enter values for Keystore Entry and Keystore View.

2. Under Persist Duration, specify the length of time in days, hours, minutes, and seconds that asynchronous messages are to be stored in the Adapter Framework message store, depending on the communication channel.
   Note

   In asynchronous message processing, the Persist Duration must correspond to at least the product of Number of Retries and Retry Interval.

3. Under Number of Retries, define how many attempts should be made to send an outbound message in the case of an error.
4. Under Retry Interval, specify the time interval in days, hours, minutes, and seconds after which the Integration Server/PCK will attempt to forward a message to the SAP Business Connector in the event of an error.