Show TOC

Configuring Queue ParametersLocate this document in the navigation structure

Use

The queue parameters control the interaction between the queue server and the index server. In particular, they specify when the queue server triggers indexing and optimization of documents. It is important for performance reasons that you have optimum settings for the queue parameters.

When TREX creates a queue it uses the default settings for the queue parameters. Depending on the document sets that you have to index initially and on the type of documents you index, you may have to change the default settings.

Note

The default settings that TREX uses for new queues are defined in the configuration file TREXQueueServer.ini. You can change the default settings. However, you should only make changes to configuration files after consulting SAP support or with a consultant.

Prerequisites

You have already created indexes.

Procedure

You can change the queue parameters for existing queues as follows:

Tool

Path

TREX Admin Tool

Start of the navigation path Queue Admin Next navigation step Queue Parameters End of the navigation path

TREX monitor in the portal

Start of the navigation path System Administration Next navigation step Monitoring Next navigation step Knowledge Management Next navigation step TREX Monitor Next navigation step Edit Queue Parameters End of the navigation path

TREX Admin Tool in the SAP System

Start of the navigation path Transaction TREXADMIN Next navigation step Queue Admin Next navigation step Set Queue Parameters End of the navigation path

For more information about the meaning of the queue parameters, see the SAP Library at help.sap.com.