Queue Administration

Use

You can do the following in the Queue area (queue administration) of the TREX admin tool (stand-alone):

Monitor queues
Configure queue parameters
Troubleshooting
Display the distribution of the queues among queue servers

Features

The figure below shows you where the queue administration area is located in the TREX admin tool (stand-alone):

The following table provides an overview of the windows and functions that are available in this area.

Window

Description

Queue Admin

Queue Info tab page

This tab page displays the following information:

Queue status (see What Does the Status of a Queue Mean?)
Number of documents in each individual document status (see What Does the Status of a Document Mean?)

You can use this information to:
Monitor queues

You can also use the following functions:
Flush

Triggering Queue Processing
Suspend

Stopping a Queue
Activate

Activating a Queue
Clear

Emptying Queues
Reset failed states

Resetting the Error Status of Documents
Create

Creating Queues
Delete

Deleting Queues

Queue Admin

Queue Parameters tab page

Displays the queue parameters.

You can check the queue parameters here and change them if necessary.

Queue Content

Documents in Queue tab page

You can display information about the processing of documents here.

You can use the Delete Entries function here to delete documents from a queue.

Queue Content

Document Attributes tab page

You can display technical information about documents here.

Queue Landscape

You can display information about the queue distribution here.

You can use the Flush function here to trigger the processing of a queue.

You require the other functions only for troubleshooting in distributed TREX systems. For more information, see the SAP NetWeaver Search and Classification TREX Single Host installation guide. This guide is located on SAP Service Marketplace at service.sap.com/instguides.