To set up a delta process, you need two InfoPackages, one to initialize the delta transfer and a delta InfoPackage to perform the delta transfer. You therefore also need two process chains in order to model the data transfer processes and to perform further processing the delta procedure.
Using a setting in the InfoPackage however, you can set an InfoPackage to be used to initialize the delta transfer. This InfoPackage is used in a process chain and will be automatically converted into a delta InfoPackage following initialization. In all subsequent process chain runs, the InfoPackage is executed as a delta InfoPackage. You therefore only need one process chain and can model your entire delta process in this chain.
The data model has already been created, together with the DataSource, transformation, InfoProvider and any other relevant BW objects.
On the Update tab page in the InfoPackage Maintenance transaction, choose Initialization of Delta Process and set the Switch InfoPackage in PC to Delta flag.
More information:Start Process
More information:Is the previous run in the chain still active?
More information:Creating Data Transfer Processes
Add any processes that are relevant for your data flow to the process chain.
For more information about process chain maintenance, seeCreating Process Chains.
The InfoPackage is handled as follows when it is executed in the process chain:
After it has been converted, the InfoPackage stays in the process chain as a delta InfoPackage.
The graphic below shows what a process chain for delta transfer to a DataStore object can look like and how the InfoPackage can be converted from an initialization InfoPackage into a delta InfoPackage: