Show TOC

Background documentationScrap Location Locate this document in the navigation structure

 

You use this activity to remove or replace a piece from a panel.

Note that you cannot unscrap or undelete an SFC number in the SFC Unscrap / Undelete activity if you scrapped or unscrapped the SFC number in the POD.

Rules

The following table describes rules and settings that you can change for this activity in Activity Maintenance:

Rule

Setting

ADJUST_SHOP _ORDER_REL_QTY

TRUE: Reduces or increases the shop order quantity released by the scrap or unscrap amount

FALSE (default): Does not modify the shop order quantity released

MAINTAIN_ LOCATION_STATE

TRUE: Does not clear checkbox values between SFC numbers if the material and its version are the same

FALSE (default): Clears checkbox values between SFC numbers

NEW_STATUS_ ONLY

TRUE: Requires the SFC number to have a status of New

FALSE (default): Allows the SFC number to have other statuses

SCRAP_LOCATION _MODE

SCRAP_LOCATION (default): Allows the operator to scrap a location

UNSCRAP_LOCATION: Allows the operator to unscrap a location

BOTH: Allows the operator to both scrap and unscrap a location

Procedure

To remove or replace a piece from a panel, proceed as follows:

  1. In POD Maintenance, create a button in the POD that points to SU590 (see POD Maintenance).

  2. In the POD, select an SFC number that has locations to scrap or unscrap (see Production Operator Dashboard (POD)).

  3. Choose the Scrap/Unscrap Location button that you have added.

  4. Select the checkbox next to the location you want to scrap or unscrap.

  5. Save your entries.