You can use the NC520
hook point activity to stop the execution of the activity at which the hook point resides when the SFC number has one or more open NC codes (see NC Code).
Note
If NC severity threshold of an NC code is Low
or None
, this hook point activity disregards it (see Sample Plan Maintenance).
This activity is commonly used with the following hook points:
PRE_COMPLETE
POST_COMPLETE
POST_CONTAINER_SAVE
POST_CONTAINER_CLOSE
The following table describes rules and settings that you can change for this activity in Activity Maintenance
:
Rule |
Setting |
---|---|
|
Specifies the number of BOM levels this activity will traverse to check for open NCs in lower level SFC numbers
|
|
Specifies the numeric value that the activity will check against the If the open NC record is associated with an Valid values: Default: Note that the |
|
Specifies the numeric value that the activity will check against the If the open NC record is associated with an Valid values: Default:
Note that this filter value overrides the |