Dynamic Routing Maintenance

You use this activity to create and maintain dynamic routings in the system.

This activity allows you to do the following:

Change the location of the SFC numbers on the current routing
Use graphical and tabular modes for creating dynamic routings (see Creating Routing Steps in the Graphical Mode)
Enter custom data values (see Custom Data)

For more information, see Creating Dynamic Routings.

The following table describes rules and settings that you can change for this activity in Activity Maintenance:

Rule	Setting
STEP_START_SEQ_INCREMENT	010,10 (default): Sets the starting step ID to 010 and the increment value to 10 for the routing steps Note The starting sequence value must be a positive integer. The increment value must be a positive integer. A comma is the only valid separator. End of the note. If not defined, the existing system-generated defaults are used.

Rule

Setting

STEP_START_SEQ_INCREMENT

010,10 (default): Sets the starting step ID to 010 and the increment value to 10 for the routing steps

Note Note

The starting sequence value must be a positive integer. The increment value must be a positive integer. A comma is the only valid separator.

End of the note.

If not defined, the existing system-generated defaults are used.