You use the PR597
hook point activity at operations where operators or machines cut SFC numbers into pieces, but the SFC numbers continue to be tracked under the same SFC number. Such operations are called DICE
operations.
To set up SFC quantity multiplication, proceed as follows:
In Operation Maintenance
, define the operation where you want the SFC quantity to be multiplied at one of the Start
or Complete
activity hook points of the operation.
Note
This activity is used most often with POST_COMPLETE
. If you set the activity at a hook point other than POST_COMPLETE
, also set the activity at PRE_SIGNOFF
or POST_SIGNOFF
so that multiplication is reversed if the SFC is signed off before completion.
In Material Maintenance
, for each material you want multiplied, enter in the Qty Multiplier
field the number by which you want the material's quantity multiplied.
Repeat steps 1–2 for each operation where you want to run the activity.