You use this activity to associate slot configurations with a resource, and to load or replenish slot configurations for a resource, as a function of Time-Based Genealogy (see Time-Based Genealogy).
This activity can be also used with the PARSE_SLOT_COMPONENT
hook point (see Hook Points).
See also: Load or Replenish
The following table describes rules and settings that you can change for this activity in Activity Maintenance
:
Rule |
Setting |
---|---|
|
If set to Note that this rule applies to both |
|
If set to |
|
If set to |
|
If set to |
|
If set to |
|
If set to |
|
Caution This rule must have the same setting for End of the caution. |
|
|
|
If set to |
The following table describes fields requiring explanation:
Field |
Description |
---|---|
|
The resource you are associating with this slot configuration |
|
Displays the setup state associated with the resource in
|
|
|
|
Identifies whether the slots have been loaded with assembly data:
|
|
Assigns a slot configuration to a resource to be run in the future and does not perform a BOM verification Note You can propose a slot configuration only if it is in the End of the note. |
|
Assigns a slot configuration to a resource to be run in the future and performs a BOM verification Note You can propose a slot configuration only if it is in the End of the note. |
|
Activates a slot configuration in the |
|
Removes a slot configuration in the Removing a slot configuration in the |
|
Unloads the slots that are loaded and all associated assembly data records on the resource from the system, including any records associated with a proposed slot configuration Removes a slot configuration in the |
|
Displays the |
|
Displays the |