snc/data_protection/max

Use this parameter to set the maximum level of data protection for connections initiated by the AS ABAP.

This parameter specifies the level of protection for connections that are initiated from the AS ABAP and where the quality of protection level for the CPIC or RFC destination is set in the SNC options to use the maximum level of protection (QoP = 9).

Default Value

3 (privacy)

Affected Parameters

snc/enable (activate SNC)

snc/data_protection/min (minimum requirement on protection level)

snc/data_protection/use (recommended level of protection)

Valid Entries, Formats

>= snc/data_protection/use

1    :     Secure authentication only

2    :     Data integrity protection

3    :     Data privacy protection