Entering content frameChanging Routings Locate the document in its SAP Library structure


You use this procedure to change the data of individual routings.

If you want to change objects in several or all of you routings, you should use one of the following procedures:

Changing Work Centers (Mass Changes)

Replacing PRTs (Mass Changes)


The following data already exists in the system:

(See R/3 Library LO Engineering Change Management, Maintaining Change Master Records)

See R/3 Library LO Engineering Change Management, Assigning a Revision Level to a Material)


  1. On the R/3 main menu choose Logistics ® Production ® Master data ® Routings.
  2. Choose Routing ® Change.
  3. Note: In the following procedure the task list type Routing is referred to, primarily in menu paths. The same paths are also valid for the other task list types (reference operation sets, rate routings and reference rate routings). If you want to maintain such an object choose the <task list type> instead of Routing.

  4. Enter the relevant data on the initial screen.
  5. Choose Enter.
  6. The screen that then appears depends on the group you entered.

    If there

    you reach the

    is only one routing in the group

    operation overview for this routing

    are several routings in the group

    header overview


  7. The further procedure depends on which data you want to change or enter. For information, refer to

Editing Header Data

Editing Operations and Sub-operations

Editing Material Components





Leaving content frame