Save As Default
When you are on the Compliance Check (Input Parameters)
screen, you can save the input parameters that you have selected as the default entries for that specific recipe or specification.
These default parameters are attached to the recipe or the specification itself. They are not user-specific entries. That is, the parameters that were saved as default will be preselected regardless of who runs a compliance check next on that same recipe or specification.
If desired, you can change the parameter entries before you run the check. The default selection is not affected; — unless you save them as default again.
Integration
When you are running a mass compliance check on a recipe or specification, and you save the input parameters as default, these default parameters will be displayed for each individual recipe or specification. However, the default parameters will not be saved for the next mass compliance check.
Example
You run a mass compliance check on Recipe A, Recipe B, and Recipe C, and save your input parameters as default. The next time Recipe A is called up (individually) for a compliance check, the input parameters will be preselected. However, if you run a mass compliance check on Recipe A, Recipe B, and Recipe C again, the input parameters will not be preselected.
Activities
From the Compliance Check (Input Parameters)
screen, select from the following input parameters:
Rating
Validity Area
Constraint Selection
Parameters for Constraint Validity
Usage of Constraint
Then choose Save as Default
. Confirm your selection in the dialog box displayed.
Note
The only parameter that you cannot save as default is the Data Origin
.