Add the SAP Datasphere Subaccount in the Cloud Connector
You need to add the SAP Datasphere subaccount to the Cloud Connector in order to connect on-premise systems to SAP BW bridge.
Prerequisites
Before configuring the Cloud Connector, the following prerequisites must be fulfilled:
-
The Cloud Connector is installed in your on-premise network. The Cloud Connector version must be 2.13.1 or higher.
For more information, see Cloud Connector Installation in the SAP BTP Connectivity documentation.
-
Before configuring the Cloud Connector, you or the owner of your organisation will need an SAP Business Technology Platform (SAP BTP) account. If you don't have an account yet, create an account by clicking Register in the SAP BTP cockpit.
-
During Cloud Connector configuration you will need information for your SAP Datasphere subaccount. Make sure that you have the subaccount information available in .
For more information, see Set Up Cloud Connector in SAP Datasphere.
-
In the source system, the SAP Notes 2703850
, 3076927
, and 3083347
must be applied. Only those SAP Notes are relevant which contain correction instructions for the respective source system. Note that SAP ECC or SAP S/4HANA source systems contain a software component SAP_BW, hence SAP Notes with correction instructions for software component SAP_BW may also be applicable in these systems.
Procedure
Results
As a result, you have added the SAP Datasphere tenant to the Cloud Connector.
In the Subaccount Dashboard section of the Connector page, you can see all subaccounts added to the Cloud Connector at a glance. After you have added your subaccount, you can check the status to verify that the Cloud Connector is connected to the subaccount.

