Displaying Messages
Use
You can display message to help analyze errors that occurred during the allocation run. If you wish, you can restrict display of messages to one cycle or one segment.
Prerequisites
Errors occurred during the allocation run. The system displays the errors in one of the following lists.
Basic list
The system displays the total number of errors in the
Number of messages
column of the
Basic list
, as well as in the basic list header. The system also displays an error message in the basic list header data.
Segment list
The system displays the number of messages for the errors that occurred in the allocation cycle in the corresponding segment list header data.
Sender list/receiver list
The number of messages for errors that occurred in a segment is displayed in the corresponding sender or receiver list header data.
Procedure
Display all messages as follows:
Click on the number of errors in the
Disp messages
row of the basic list header data.From one of the other lists, choose
Goto
Messages
Selection.
Display all messages of a cycle as follows:
Click on the number of errors in the
Disp messages
row of the basic list header data.In the segment list, choose
Goto
Messages
Selection
.
Position your cursor in the basic list on the cycle and choose
Goto
Messages
Select
.
Display all messages of a segment as follows:
In sender or receiver list header data, select the
No. of errors
.In the sender or receiver list, choose
Goto
Messages
Selection
.
The system displays a dialog box for display of messages.
To display more information on an error, either select the message by double-clicking it, or position your cursor on the message and choose
.
Choose
to leave the dialog box.
Result
You can analyze errors. You can redefine the cycles in accordance with the message and then execute the allocation again.
Note
If the message analysis is not sufficient, repeat the allocation and create a runtime log. To do this, select
Runtime log
in the dialog box via
Settings
.