Developer

SmappStateProcessingAction

The SmappStateProcessingAction class controls state and application processing. Use it to signal the processing engine that further processing is intended.

The processing engine recognizes three signaling actions: continue, wait, and terminate, which you can send by calling:
  • continueProcessing (SmappState) – continues execution to the specified follow-up state. Causes an infinite loop if the follow-up state is the same as the calling state. Termination must be handled within the state.
  • waitForMessage() – pauses execution and waits for a response, then continues execution to the specified follow-up state.
  • terminateProcessing () – terminates the application.
States that extend the SmappStatePlugin class, implementing logic inside the processStateLogic method need not explicitly call continueProcessing or terminateProcessing. The same functionality is accomplished by returning the follow-up state from the processStateLogic method. For example, instead of calling continueProcessing, return the follow-up state using one of the helper methods:
  • continueOk()
  • continueFail()
  • continueDyn()

To terminate processing, states should call continueFail, and let the state-editor configuration determine what to do. If the state is not configured to forward continueFail calls to a follow-up state, the application automatically terminates.

To enable states to send messages and wait for replies before they continue processing, call waitForMessage.

To display a message control in the state editor, call supportsSendSmsMessage.