Receiver Agreement

MessageHeaderID (in Common folder)

Specifies object key

The same data structure is used for the object key for receiver determinations, interface determinations, sender agreements, receiver agreements, and direct connections.

More information: Receiver Determination

Note that for a receiver agreement you must enter the name and namespace of the receiver interface.

ReceiverAgreement (or RestrictedReceiverAgreement)

Defines the receiver agreement with all attributes.

• MasterLanguage, AdministrativeData, and Description; more information: Cross-Object-Type Elements

• ReceiverAgreementID: Object Key

• CommunicationChannel: Specifies the assigned receiver communication channel.

• SoftwareComponentVersion: Software component version of the receiver interface.
• SchemaValidationIndicator: Specifies if and where the XML schema validation is to be performed. For more information, see SAP Library at SAP Process Integration  SAP Process Integration (Function-Oriented View)  Integration Engine  Processing XML Messages  XML Validation.
• VirusScan: Specifies if and how the virus scanner should be activated. You have the following options:
  • Use Global
  • No Virus Scan
  • Virus Scan by Adapter

  For more information, see SAP Library at SAP Process Integration  SAP Process Integration (Introduction)  Development and Configuration Tasks (Dual-Stack)  Advanced Development Tasks (Dual-Stack)  Security-Related Tasks  Enabling Virus-Scanning of Messages.

• AdapterSpecificAttribute: Adapter-specific attributes of the receiver determination.

  The adapter-specific attributes are dependent on the adapter type of the assigned communication channel.

• AdapterSpecificTableAttribute

• HeaderMapping: Specifies the header mapping.

  For more information, see below.

• PrefixNamespaceMapping: Specifies the mapping from a namespace to a prefix (example: p1 := http://sap.com/xi ). This parameter is relevant when you use XPath expressions in the condition.

HeaderMapping

Defines the header mapping.

You enter the sender and receiver for the header mapping.

CommunicationPartnerExtractor

To be able to specify the sender or receiver in the header mapping, you must enter for both the sender or receiver party the name, identification schema, and the issuing agency and the name of the sender or receiver service.

Therefore you have four parameters each for both the sender and receiver.

• CommunicationParty

• CommunicationPartySchema

• CommunicationPartyAgency

• CommunicationComponent

  All parameters are based on type Extractor.

  For more information on defining an expression based on type Extractor, see Receiver Determination (Section Structure of Expressions).