Activating or Deactivating Inspection Types

Prerequisites

  • You must have edited the QM-specific data in the Quality Management view of the material master.

  • You can activate an inspection type under the following conditions:

  • If it is not stock-relevant

  • If it is stock-relevant and at least one active stock-relevant inspection type exists

  • If it is the first stock-relevant inspection type and no inspection stock exists, or if you set the indicator Activate despite insp. stock

  • When you deactivate the last inspection type relevant to stock, there must be no inspection stock for the material. To do this you must post the inspection lot quantities out of the inspection stock.

Procedure

  1. Choose Start of the navigation path Logistics Next navigation step Quality management Next navigation step Quality planning Next navigation step Logistics master data Next navigation step Material Next navigation step Inspection setup End of the navigation path

  2. Choose Activate insp. type or Deactivate insp. type .

  3. Select the materials, for which you want to activate or deactivate the inspection type. You can make the selection by using the plant, material, the material type and the material class.

  4. Enter the required inspection type.

  5. Edit the following indicators:

Indicator

What You Should Know

Assign inspection type (only in the activation function)

If you set this indicator, the system activates the inspection type in the materials, and adds it to those materials, to which the type was not previously assigned.

If the inspection type did not exist, the system copies the parameters that are defined in Customizing as default values for the inspection type.

Activate despite insp. stock (only in the activation function)

If you set this indicator, inspection lots are created automatically, when you activate the first stock-relevant inspection type, to avoid stock inconsistencies between QM and MM. The inspection type for the inspection lots to be created is taken from Customizing .

If you do not set this indicator, the inspection type for a material is only activated, if no stock inconsistencies will occur between QM and MM without the creation of additional inspection lots.

Do not display material list

If you set this indicator, the system immediately activates the inspection type for all selected materials, when the program is run.

If you do not set this indicator, the system displays a list of materials. From this list, you can select the materials, for which you want to activate the inspection type.

Create change documents

If you set this indicator, change documents are created for all changes that are made to the materials. You can display these change documents in the material master record.

If you want to distribute inspection setup data via ALE, using change documents , you must set this indicator. This ensures that all changes to the inspection setup are distributed in other systems.

  1. Choose Execute.

If you set the Do not display material list indicator, the chosen inspection type is activated immediately for all selected materials.

  1. If you do not set the Do not display material list indicator, select the materials from the list, for which you want to activate or deactivate the inspection type and choose Continue .

  2. Save the data.

Additional Functions in the Selection List for Mass Change

Function

Pushbutton

What You Should Know

Display inspection setup

Display inspection setup

You switch to the inspection setup in the Quality Management view of the material master.

Display stock overview

Stock

You switch to the stock overview for the chosen material.