Use

In an audit run, you can determine which subrequirements and auxiliary conditions the student satisfies and which not, and which ones are still in process (see also Audit Overview ).

You can evaluate the data automatically with the following report programs:

RHIQAUDIT_MP_CP (Audit (Process-Dependent))

RHIQAUDIT_MP_CS (Audit (Process-Independent))

You can use the BSP application PIQ_AUDIT to make corrections in audit runs. The BSP application enables you to make manual changes, for example, if a result is not fulfilled.

If the subrequirements are index-dependent, the system performs the evaluation as follows:

The assigned academic work objects are used as the calculation basis for performance indexes.

The system compares the performance indexes with the target values (see Features under Requirement Catalog ), and determines whether or not the student fulfils the subrequirement.

If the subrequirements are index-independent, the system performs the evaluation as follows:

The system evaluates the condition (see Features under Requirement Catalog ).

The system determines whether the student meets the subrequirement from the result.

If all of the subrequirements of a requirement are fulfilled, then the requirement itself is fulfilled. If the requirement has an auxiliary condition, the requirement is fulfilled when all the subrequirements and the auxiliary condition are fulilled.

If only the auxiliary conditions of a requirement have to be fulfilled, and not the implicit condition ("100 % of all subrequirements must be fulfilled for the requirement to be fulfilled“) and auxiliary conditions, you can switch off the implicit condition. If you do not switch it off, all subrequirements and auxiliary conditions must be fulfilled.

You can also perform these steps manually and overwrite the system defaults if the BSP application view you are using allows this.

If you execute or change requirements manually, you can have the system generate a module proposal for each subrequirement. This is advisable in cases where the student has not completed any academic work which fulfils the subrequirement. You can use a search function to find the modules. You can assign these modules to subrequirements, for example, if you want to simulate specific configurations.

You want to simulate the following audit runs:

Audit run with another program, for example for a change of program

Audit run with another academic specialization

Audit run with possible module choices

Prerequisites

You have created a requirement profile for the student.